This is how you configure ALOM for ethernet from the SERIAL
    console:

    ## ENTER ALOM CONSOLE

    #.

    # setup ALOM password for the admin account
    password
    ## set to real$#@! for realnet RN2

    # configure SC

    setupsc
    Entering Interactive setup mode. To exit and discard changes to
    that point, use Ctrl-C or to exit and save changes to that
    point, use Ctrl-Z.
    Do you wish to configure the enabled interfaces [y]? y
    Should the SC network interface be enabled [y]? y
    Should the SC email alerts be enabled [y]? y
    Do you wish to configure the network interface [y]? y
    Should the SC use DHCP to obtain its network configuration [n]?
    n
    Enter the SC IP address [100.100.100.100]? xxx.xxx.xxx.xxx
    Enter the SC IP netmask [255.255.255.0]? xxx.xxx.xxx.xxx
    Enter the SC IP gateway address [100.100.100.100]? xxx.xxx.xxx.xxx
    Should the TPE link test be enabled [y]? y
    Do you wish to configure the managed system interface [y]? y
    What level of SC events should be reported to the managed system
    where valid settings are 0 (none), 1 (critical), 2 (critical and
    major) and 32
    What action should the SC invoke if the OS is hung. The
    available options are 'none', 'xir' or 'reset' where an xir will
    attempt to collect die
    How many seconds should be allowed for an XIR to complete
    (maximum timeout of 10800s) [900]? 900
    Do you wish to configure the network management interfaces [y]?
    y
    Enter the number of mail servers to configure [0]? 0
    Do you wish to configure the SC parameters [y]? y
    Enter any customer data for this platform (maximum of 40
    characters) []? Realnet Systems RN2
    Enter the console session escape sequence (2 characters). The
    first character can be any printable characters or control-A
    through control-Y e.
    Enter level of events to be displayed over the CLI where valid
    settings are 0 (none), 1 (critical), 2 (critical and major) and
    3 (critical, ma2
    Should poweron sequencing be enabled [y]? y
    Enter the SC cli prompt (maximum of 16 characters) [sc]? rn2-sc
    Enter the SC CLI timeout in seconds (maximum of 10000s) [0]? 0
    Should password entry echo '*'s [y]? y


    ### SHOW THE SC CONFIG
    showsc

    ## RESETSC for changes to take effect
    resetsc -y


------------------------------
Credit goes to my good friend:
------------------------------
Rajesh Goel, CISSP
cell (917) 685-7731
CTO: Brainlink International, Inc.
"IT Crisis Management and Solutions"
HIPAA, Sarbanes-Oxley & GLBA Information Security Compliance
------------------------------